Distributors Wanted!!!! Please contact us if you are interested in becoming a distributor of the new LAVA-BRICK and/or HIDE-A-BRICK



 

Installation Procedures

Interior Installation
Please contact your local handyman service for installation.

 
For Do-It-Yourselfers.
Masonry Exteriors:

New Construction:

Simply substitute the HIDE-A-BRICK® for a standard building brick beside each outdoor faucet as the wall is being laid.

Existing Construction:

  1. Pulverize an existing brick with a 3/4" by 18" piece of galvanized pipe and a 2 pound hammer.* This should take about 10 minutes.
  2. Apply "mortar repair" caulking to the HIDE-A-BRICK® with a caulking gun and then insert into the opening.

Wood Exteriors:

  1. Hold the HIDE-A-BRICK® against the wall and scribe the outline with a pencil to form a box.
  2. Drill four holes just inside the four corners of the "smaller" box.
  3. Use a jig saw to complete the cut out.*
  4. Apply a liberal amount of silicone caulk to the housing of the HIDE-A-BRICK® and then push into place.

*Always use adequate eye protection.

RickCo Products Globe 2008 All rights reserved. Hide-A-Brick ® and Lava-Brick ® are Registered Trademarks of the Patented inventions of RickCo Products, Inc. Disclaimer: Please note that RickCo Products, Inc. and Now Marketing,Inc. assume no liability in association of the use of said products.